The ToyoTA CORELLA Keyless Security Alarm Installation Manual is designed to guide the user through the installation process. It begins with preparation, including familiarizing oneself with the instructions, inspecting the kit components, and verifying that the vehicle shorts pin is installed. The manual then covers vehicle preparation, disconnecting the negative battery clamp, and removing the scuff plate and kick panel.
Installation Preparation
Before starting the installation, the user must inspect the kit components, disconnect the negative battery clamp, remove the scuff plate, and remove the kick panel.
Installing the LED Valt Switch
Installation of the LED Valet Switch requires drilling a 5/16 diameter hole in the center of the left side lower dash finish panel. The knurled mounting nut is then passed through the hole and secured with the switch. If a trim bezel is supplied, the center knock out must be removed and the new trim bezel installed.
Preparing the LED Valet Switch
The user must locate the 4-pin Molex connector, carefully plug the terminals, and secure the switch to the main vehicle harness.
Mounting the Shock Sensor Module
The shock sensor module must be secured to the main vehicle harness using short black cable ties. The user must ensure that the cable ties pass through the holes in the upper and lower mounting tabs of the shock sensor.
Mounting the Main Control Module
The main control module must be secured to the vehicle harness connected to the JB in the driver’s side kick panel area. Long cable ties must be used to secure the module, passing the cable through the module eyelets as shown.
Manual:
Download: TOYOTA COROLLA Keyless Security Alarm Installation Manual
Chat: Powered By VoiceSphere
