Installation Instructions for Needle Bearing Eliminator for 8″ IFS Clamshell (2005-CURRENT Toyota Tacoma)

Important Notices

Read instructions completely before installing this product. Refer back to the instructions frequently during installation.

Caution: Flying Object Hazard, Fluid Splash Hazard. Wear safety glasses at all times when working on vehicle.

Warning: Cancer and Reproductive Harm. Visit www.P65Warnings.ca.gov for more information.

Recommended Tools

Flat End Screwdriver, Transmission Jack, Ball Peen Hammer, Wheel Bearing Grease, Rubber Mallet, Torque Wrench, Safety Glasses, CV Joint Puller, Metric Ratchet & Socket Set, Metric Wrench Set, Seal Driver Kit, Needle Bearing Puller, API GLS SAE 90 Hypoid Gear Oil (Approximately 1.5 quarts)

Installation Steps

Step 1: Place the vehicle on Jack stands, remove the driver’s side wheel.

Step 2: Remove the transfer case drain plug and drain the oil.

Step 3: Separate the Front Speed Sensor from the steering knuckle.

Step 4: Separate the tie rod end from the steering knuckle using a tie rod end remover.

Step 5: Remove the front axle hub grease cap with a screwdriver and ball peen hammer.

Step 6: Remove the (2) bolts and separate the front lower ball joint attachment from the steering knuckle.

Step 7: Remove the CV Joint assembly with a CV Joint puller tool.

Step 8: Remove the stock needle bearing from the carrier using a needle bearing remover.

Step 9: Install the needle bearing eliminator into the carrier using a seal driver.

Manual:

Download: Installation Instructions for Needle Bearing Eliminator for 8″ IFS Clamshell (2005-CURRENT Toyota Tacoma)

Chat: Powered By VoiceSphere