This shop manual provides information on inspecting and replacing the 30A DC fuse for the eCompressor in the 2017 KIA Optima Hybrid (JF HEV), Optima Plug-in Hybrid (JF PHEV), and Niro (DE HEV) vehicles.
Important Safety Precautions
Before performing this procedure, follow all EV battery safety precaution procedures found in the “General Information General Safety Information and Caution” chapter in the Shop Manual on KGIS and wear all required Personal Protection Equipment (PPE). Failure to follow the safety instructions may result in serious electrical injuries.
Inspection/Replacement Procedure
Remove the Hybrid Control System Safety Plug by referring to the “Hybrid Control System High Voltage Shut-off Procedures chapter in the applicable Shop Manual on KGIS. Then, open the hood and remove the air intake duct (if applicable), disconnect the power cable and inverter cable, and remove the upper three cover retaining bolts to access the fuse housing. Inspect the fuse for continuity, and replace it if necessary.
Confirm proper operation of the eCompressor after replacing the fuse.
Manual:
Chat: Powered By VoiceSphere
