Ferrari Technical Information: Calibration Procedure for ADAS Systems (2019)

Introduction

This technical information provides the correct calibration procedures for Advanced Driver-Assistance Systems (ADAS) in Ferrari vehicles.

Important Notes

ADAS systems play a fundamental role in vehicle safety, and calibration must be carried out exactly as instructed.

The calibration procedure consists of two stages: initial static calibration and dynamic calibration test drive.

Preconditions for Calibration

The vehicle must be in proper running condition, with no passengers, a full fuel tank, and all fluids at correct levels.

The vehicle must be aligned correctly with the calibration kit, and the front lid must remain closed throughout the procedure.

Radar Calibration Procedure

This procedure is necessary in cases such as removal or replacement of front bumper, repair on suspension, or replacement of the radar.

Update the DASM with the latest SW version and perform the “NBC Proxy Alignment” cycle with the DEIS diagnostic tool.

Manual:

Personalization Programme This programme provides details on the personalization options available for the Ferrari F8

August 5, 2024

Introduction This technical bulletin provides instructions for replacing the CCP (Clutch Control Pack) on the

May 7, 2024

Introduction This technical bulletin provides information on the E-FEO 10 LaFerrari battery maintainer, including its

May 8, 2024

Recall Campaign Overview Ferrari has initiated a recall campaign for certain Ferrari Roma models manufactured

May 13, 2024

This technical information supersedes the previous TI 2142 of December 2013 and provides instructions for

October 1, 2024

Certification Details The California Air Resources Board has certified the 1995 Ferrari F355 Berlinetta, GTS,

May 9, 2024

Introduction