Important Notice
This part is legal for use only in competition racing vehicles as defined under California law and is not legal for use in any other motor vehicle.
Use of this part in any other vehicle may subject you to fines and penalties for violation of federal and/or state law and will void your warranty from Burger Motorsports, Inc and can void your vehicle’s warranty.
Installation Steps
1. Open hood, lock doors, and place key far enough away not to wake up the vehicle. Wait a few minutes for car to go to sleep.
2. Remove the plastic engine cover by lifting it off.
3. Locate and unplug the factory TMAP sensors by pressing down the tab and sliding out the factory connector from the sensor.
4. Plug in the JB4 connectors to the factory sensors, and plug the factory plugs in to the JB4 harness, completing the loop.
5. Tuck the control box under the brake booster.
Manual:
Download: BMS Infiniti Q50 Q60 VR30 Stage & JB4 Install Guide
Chat: Powered By VoiceSphere
