Introduction
Voodoo13 recommends that installation of all Voodoo13 parts be completed by a professional who is experienced in suspension tuning.
Installation Procedure
Step 1: Lift the vehicle to a safe height using the recommended factory lift points to work underneath the front suspension. Ensure to place safety jack stands where recommended by the manufacturer’s service manual before anyone goes underneath the car (unless using vehicle lift with safety locks).
Step 2: Remove the nut securing the endlink to the sway bar using a 17mm socket.
Step 3: Remove the nut securing the endlink to the lower control arm using a 19mm wrench and a 17mm socket.
Step 4: Adjust the endlink to the same length as the factory endlink.
Step 5: Connect the endlink with the smaller spacer side to the sway bar and the bigger spacer side to the lower control arm.
Step 6: Properly torque both nuts to 50 ft-lbs using a torque wrench.
Step 8: Once the lengths of the endlinks are established, tighten the jam nuts against the female hem joint on both sides.
Warranty
Voodoo13 offers a Limited Lifetime Warranty for its products against defects and workmanship when used on light truck and car applications under normal operating conditions.
WARNING: High performance parts. For off-road use only. Installation should be carried out by a qualified facility. Improper use or installation may result in injury or death.
Manual:
Chat: Powered By VoiceSphere
