This installation manual provides instructions for installing a Fog Lamps Install Kit on a PT Cruiser.
Important Notes
The kit must be installed according to the instructions provided. State and local regulations may also apply.
Required Tools and Materials
The following tools and materials are required:
- Large flat screwdriver
- 10mm wrench
- Phillips screwdriver
- 1/2″ drill bit
- Drill motor
- Utility knife
- Wire routing tool
- Electrical tape
- Silicone sealant
- Hooked pick tool
- Trim stick
- 10mm socket
- 6mm socket
- Socket wrench
- T10 torx driver
Step-by-Step Installation Instructions
The manual provides detailed step-by-step instructions for installing the Fog Lamps Install Kit. The steps include:
- Disconnecting and isolating the negative battery cable
- Pulling out the air cleaner assembly
- Removing the upper and lower steering column shrouds
- Checking for existing wiring in cavities 13 and 14
- Installing the fog lamp harness
- Installing the 15 amp fuse
- Installing the headlamp switch
- Securing the fog lamp harness
- Connecting the lower left I/P panel
- Installing the right front tire
- Installing the right fog lamp
- Installing the left fog lamp
- Connecting the power harness ground wire
- Lowering the vehicle
Manual:
Download: FOG LAMPS INSTALL KIT PT CRUISER INSTALLATION INSTRUCTIONS
Chat: Powered By VoiceSphere