Installation and Precautions
The following instructions are for the installation and use of the genuine Mazda mud flap (rear) on your Mazda 2 vehicle.
Before Installation
Before starting the installation, ensure that you have read and understood all the instructions. Make sure to remove any parts and accessories from the vehicle that may interfere with the installation.
It is also recommended to consult the applicable workshop manual for removal and installation of vehicle parts to ensure proper installation and to avoid any potential damage or accidents.
Installation
First, remove the splash shield and cut out the necessary holes for the mud flap. Then, align the mud flap with the rear bumper and splash shield installation holes and temporarily tighten the kit bolts and reusable lower rear bumper bolt.
After tightening the bolts, ensure that all bolts, fasteners, and screws are securely tightened. Check for any excessive gaps and retighten the bolts if necessary.
Precautions
When using the mud flap, take note of the following precautions:
Do not modify the mud flap: Ensure that you handle the mud flap with care and do not install it in any way other than described in the instructions.
Do not wash the vehicle through an automatic car wash: This may damage the mud flap. Also, be careful when parking on a road shoulder or entering/leaving a road shoulder or bump, as the mud flaps may be damaged if the vehicle height is lowered.
Keep the vehicle clean: Wipe off any gasoline, engine coolant, or battery fluid that may adhere to the painted surface of the resin parts immediately to avoid discoloration or stains.
Manual:
Download: Mazda 2 Genuine Mud Flap (Rear) Installation and User’s Instructions
Chat: Powered By VoiceSphere
