TRIAD N-257MG Power Transformer Datasheet

triad-n-257mg-power-transformer-datasheet.pdf

Electrical Specifications The N-257MG power transformer has a maximum power rating of 500 VA, with an input voltage of 230 V at 50/60 Hz and an output voltage of 115V (+/- 5%). The full secondary load current is 4.35 Amps RMS, and the voltage regulation is 5% typical from full load to no load. Description […]

DRY TYPE DISTRIBUTION TRANSFORMERSGROUP J, K, AND L

dry-type-distribution-transformersgroup-j-k-and-l.pdf

Transformer Details The datasheet provides information on Dry-Type Distribution Transformers, grouping J, K, and L, with 600 Delta primary volts, and various secondary voltages and frequencies. Dimensions and Measurements The table provides approximate dimensions, weight, and knockouts for different transformer sizes, including height, width, and depth in inches (cm) and weight in pounds (kilograms). Electrical […]

Extracted datasheet title: Miniature Basic Switch

extracted-datasheet-title-miniature-basic-switch.pdf

The Miniature Basic Switch offers high reliability and security with a wide variation of best-selling microswitches that can be used for interrupting current when doors are opened or closed. Ratings The switches have ratings for 21A and 16A at 250VAC, with maximum operating forces ranging from 0.98N to 4.71N. Actuator and Terminals The switches have […]

Quartz SMD

quartz-smd.pdf

Overview The datasheet provides information on the Quartz SMD module, available in three variants: HC49M, HC49J, and HC49H. It highlights the module’s high reliability, extended temperature range, and suitability for automotive applications. Specifications The module features frequency ranges, tolerance, and temperature ranges, as well as load capacitance, series resistance, and insulation resistance. It also provides […]

Series 100 thru 111 DIP Jumpers Datasheet

series-100-thru-111-dip-jumpers-datasheet.pdf

Introduction This datasheet provides information on the Series 100 thru 111 DIP Jumpers. Product Information The Series 100 thru 111 DIP Jumpers are available with various configurations, including the “L” and “W” options. For more information, see Data Sheet No. 11006. Cable Detail The Series 106, 108, and 110 DIP Jumpers are available in twisted […]

Standard High Pass Filters

standard-high-pass-filters.pdf

Summary Rugged and lightweight high pass filters with sharp rejection below the cutoff frequency, suitable for extreme environmental conditions. Key Features Designed for operation over a frequency range of 10 MHz to 10 GHz Low insertion loss and VSWR in the pass band Impedance: 50 ohms Specifications Available in various models, including 20, 40, and […]

Two Electrode Gas Tube Surge Arrester Y-602B RoHS

two-electrode-gas-tube-surge-arrester-y-602b-rohs.pdf

The Y-602B surge arrester is designed for transient voltage surge suppression (TVSS) in various applications such as power supplies, CATV systems, antennas, test equipment, and digital satellite systems. Key Features UL 1449 listed, RoHS compliant, and non-radioactive Low capacitance and high insulation resistance Proven performance, ISO 9001 certified, and world-renowned quality Electrical Characteristics DC breakdown […]

LIGIER LEL LIGITEK BACKLIGHT Package Dimension

ligier-lel-ligitek-backlight-package-dimension.pdf

Overview The LIGIER LEL LIGITEK BACKLIGHT Package Dimension datasheet provides information on the physical and electrical characteristics of the LEL backlight module. Physical Characteristics The package dimension is specified as 89 x 86 mm with a tolerance of ±0.25 mm, unless otherwise noted. The module has a 5-pin connector and a total of 2 x […]

I Series Crystal

i-series-crystal.pdf

Data Sheet Overview: This datasheet provides specifications for the I Series Crystal, a ceramic package resonator with a frequency range of 10.00MHz to 80.00MHz. The crystal offers tight tolerance and stability, making it suitable for various applications. The datasheet also covers environmental and mechanical details, including shock, vibration, and solderability testing according to MIL-STD-883 and […]